Do you have room that might utilize a ceiling fan Installing a ceiling fan is as easy as changing your current light fixture. All of the cabling you need is already around so the only thing is to change the existing workbox with one that is made for the weight of a ceiling fan. If you dont change the present workbox to something that can cope with the weight could cause disaster. Before you start your project, go through the instructions for the fan you have bought, and make sure that you have all of the needed tools.

Should you decide to install the fan at a cathedral type ceiling, you very well may need to get parts to boost the fan lower. Given that you are all set for the real installation, ensure that the breaker is switched off, so no power is delivering to the light you are replacing. After removing the current light fixture, verify to see if the installed workbox can handle the weight of your ceiling fan. Nearly all workboxes are not made for ceiling fans, you will need extra support. This could be done rather quickly if you have access to the attic, and are capable to get to the spot of the new fan.

To be able to extra support, you nail a 2x4 within the ceiling rafters where it hits the top of the workbox. Be positive that the 2x4 is anchored and then attach on the box to the wood. If everything is done the right way, the extra weight of the fan will now be absolutely supported by the wood and the screws. In cases where you are incapable to do it from the attic room or you have simply no attic, you will have to create a cross bracing in your ceiling. This is tougher to do, and perhaps not as protected in the end, but will have to do with no attic admittance.

Now, after assembling the fan according to the instructions, you are prepared to put your new fan. The hard part is positioning the fan, while hooking up the wiring. It depends on the form of fan you have, some come with a bracket with a J hook while others have a hanging frame. For the majority of fans the wall switch will turn the device on or off, while the chain will control the speeds. If you want a light kit along with your fan, they can be manged by either chain or wall switch.

Electrical wiring the fan is as easy as connecting two black wires, two ground wires and a couple white wires. woodworking plans Once you have completed assembling the fan and wiring, the last step is to attach the fan blades. Immediately after you connect the blades, the only thing left is to flip the breaker back on to notice if you did it right.