Do you use a room that could use a ceiling fan to cool it down Its certainly not difficult to install a ceiling fan by yourself if you are planning to replace a light fixture. All of the cabling will already be there, therefore the only obstacle will be replacing the old workbox with one that is authorized for the weight of a ceiling fan. If you dont change the present workbox to something that can handle the weight could cause disaster. Right before you carry out anything, read the manuals for your fan very cautiously and make certain you have the necessary tools.

woodworking plans Should you decide to have the fan on the cathedral ceiling, you will have to acquire an extension so the fan wont be so high up. Now that you are prepared for the real installation, ensure that the breaker is switched off, so no power is going to the light you are swapping. After eliminating the current light fixture, check to see if the installed workbox can tackle the weight of your ceiling fan. Almost all workboxes are not aimed for ceiling fans, you will need added support. Adding support to the workbox is not that difficult if you have access to the light fixture from the attic.

To help extra support, you nail a 2x4 inside the ceiling rafters where it touches the top of the workbox. Make sure that the 2x4 is attached and then screw on the box to the wood. If everything is carried out correctly, the excess weight of the fan will now be fully supported by the wood and the screws. If you dont possess entry to the attic, you will ought to place a cross bracing in your ceiling. Doing this is more of a challenge and may not be as secure as using a 2x4 but it is the best you can do if you dont possess access to the attic.

When you have assembled the fan correctly, you are now all set to hang your fan. pre made woodworking plans The tough part is hooking up the wiring while holding the fan. The difficulty is according to the form of fan you have, whether it is a draping frame or a fan that has a bracket with a J hook. Most fans, you will see a wall mount switch using a chain to manage the speed of the fan. If you determine to also deploy a light kit with the fan, both can be regulated by either chain or wall switch.

Electrical wiring the fan is simply by connecting two black wires, two ground wires and two white wires. Once you have completed putting together the fan and wires, the last step is to install the fan blades. As soon as that is done, turn the breaker back on to see the results.